| 1. |
Disconnect the battery negative terminal (A).
Tightening
torque:
(-) terminal : 4.0 ~ 6.0N.m (0.4 ~
0.6kgf.m, 3.0 ~ 4.4lb-ft)
| |
| 2. |
Remove the engine cover
(B). |
| 3. |
Remove the air duct (C).
|
| 4. |
Disconnect the breather hose (A), air intake
hose (B) and then remove the air cleaner assembly (C).
Tightening
torque
Hose clamp bolt:
2.9 ~ 4.9N.m (0.3 ~ 0.5kgf.m, 2.2 ~
3.6lb-ft)
Air cleaner assembly bolts:
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~
8.7lb-ft)
|
|
| 5. |
Loosen the drain plug (A), and drain the
coolant. Remove the radiator cap to speed draining.
|
| 6. |
Remove the radiator upper hose
(A).
|
| 7. |
Disconnect the OCV connector (A).
|
| 8. |
Disconnect the VIS connector (A), the oil
pressure switch (B), the knock sensor connector (C), the A/C
compressor switch connector (D) and the alternator connector
(E).
|
| 9. |
Disconnect the Injector connectors
(A).
|
| 10. |
Disconnect the VCM connector (A).
|
| 11. |
Disconnect the ETC connector (A) and the MAP
& IATS connector (B).
|
| 12. |
Disconnect the PCV hose (A).
|
| 13. |
Disconnect the fuel hose (A).
|
| 14. |
Disconnect the brake booster vacuum hose (A),
PCSV hose (B) and the throttle body coolant hoses (C).
|
| 15. |
Remove the intake manifold stay (A) and then
disconnect the sensor connectors from the mounting
bracket.
Tightening
torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~
17.4lb-ft)
|
|
| 16. |
Remove the intake manifold (A).
Tightening
torque :
Bolts & Nuts :18.6 ~ 23.5N.m (1.9 ~
2.4kgf.m, 13.7 ~ 17.4lb-ft)
|
|
| 17. |
Installation is reverse order of
removal. | |
